Technical Support for Thule, Yakima, Swagman and Proline Bike racks, ski racks, cargo carriers, kayak and canoe racks.

You are here  Roof Racks  Permanent Mount  Open Road Rack

TECHNICAL SUPPORT AND INSTRUCTIONS FOR PROLINE OPEN ROAD ROOF RACKS

Product Listing

Details: Below you will find technical support and instructions for the product you selected. For more detailed information please contact us.

Roof Racks   Roof Accessories   Bike Racks   Ski Racks   Cargo Carriers   Water Sport Carriers   Hitch Mount Racks   Hitch Accessories   Pickup Truck Racks   Truck Bed Rails   Spoilers   Trunk Deck Racks   Window Graphics   Truck Tie Downs   Car Pet Barrier   Clearance Deals   Gift Certificates   Contact Us   Testimonials

Sizes to fit any vehicle in stock!! Custom sizes available at no additional charge. Tools Required: - Phillips head screw driver - Electric Drill and 3/64"inch drill bit **PLEASE READ ENTIRE DIRECTIONS PRIOR TO INSTALLATION**

Monthly Specials

1.] Assemble crossrails to stanchions. Insert Stanchion (1) into into opening on Crossrail (5) as shown in      illustration. Secure with crossrail screws (8) from the underside. 2.] Note Orientation of Stanchions (1) while assembling. Both rails should be oriented so that the Stanchions (1) slope       down toward the front of the vehicle. See diagram "A". 3.] Carefully place the rack on the vehicle for locating and centering. 4.] Spread the crossrail assemblies out as far as possible on the end slats (3) and center the frame from side to side.       Make certain that tailgates, etc. do not interfere with the rack when open. Use a tape measure to insure proper       centering. MEASURE BEFORE DRILLING. 5.] Mark hole locations with a felt tip pen or pencil using the holes in the end slats (3) as a template.      Remove rack carefully. 6.] Center Punch Hole locations to prevent drill slippage. Drill 3/64" inch diameter holes. CAUTION : DO NOT DRILL      THROUGH HEADLINER. Use a short drill (1/4" exposed ) or a drill stop. Remove chips carefully. 7.] Replace rack over holes. Position the End Slat caps (4) on the ends of the End Slats (3) and secure both to      the vehicle roof using Self- Sealing Screws (6). 8.] Place Vinyl Middle Slats (9) on the roof between end slats (3) and space evenly while keeping the ends flush.      Clean the area where the slats are to be installed with a good cleaner and wax remover prior to installation.       Remove 3M plastic backing from the underside of the middle slats (9) and install carefully. 9.] Rotate locking levers to front or back to lock crossrails in place. Center position levers to adjust crossrails.      Twist locking tie down loops to lock and/or reposition.

Shop by Manufacturer:    Thule     Yakima      Swagman      Just-Rite      Barrecrafters      Mont Blanc      Proline      PerryCraft                                          Fulton      StowAway 2      Bull Ring      GlassScapes

About Us      Directions      Email Us      Return Policy      Shipping & Transit Times      Security & Privacy      Help